Las Vegas · Appliance repair
Washer Repair
Leaks, drain faults, error codes and spin problems, across the Las Vegas valley.
A washer faultis usuallyone part.
What to expect
- Leak diagnosis and repair
- Drain pump replacement
- Spin and agitation faults
- Door lock and lid switch repair
Common causes
- Torn door boots and seals
- Blocked or failed drain pumps
- Worn hoses and couplings
- Door lock and switch failures
Scheduling
CallOpen daily, 8 AM–10 PM. Tell us the appliance, the brand and what it is doing.
Serving 3 local communities(725) 777-7750What we fix onwashers.
The fault is diagnosed and explained before any repair goes ahead.
Leak diagnosis and repair
Trace the leak to the door boot, a hose, a coupling or the drain pump, then repair it.
Drain pump replacement
Check the pump filter and drain hose first, then test and replace the pump if it has failed.
Spin and agitation faults
Test the drive motor, belt, coupling and switches when the drum will not spin or agitate.
Door lock and lid switch repair
Test the lock or switch that tells the washer it is safe to fill and spin.
Door boot and seal replacement
Replace a torn or worn door boot that lets water out at the front of the machine.
Error code diagnosis
Read the code, then test the part it points to rather than replacing parts on the code alone.
We find the part behind the leak,the drain fault or the code.
Leak traced. Part confirmed.
Front-load and top-load washers are both serviced. The leak or fault is traced to its source before any part is replaced.
Some models let you clear the pump filter yourself. If that does not fix a drain fault, the pump and hose are tested next.
Learn about our process
The failed part is confirmed before it is replaced.
What you notice
Water on the floorSymptomUsually seen after a cycle, at the front of a front-loader or underneath the machine.
Likely cause
Seal, hose or pumpDiagnosisA torn door boot, a worn hose or coupling, or a leaking drain pump.
What gets checked
Seals, hoses, pumpBefore repairEach is inspected so the leak is traced to its source, not patched where it shows.
From the first call to a finished cycle.
Five stages. The fault is confirmed before parts are ordered, and you decide on the repair before work starts.
Call us
Tell us the brand, front-load or top-load, and any error code shown.
When you callCheck the symptoms
The cycle is run or the code read to narrow down the fault.
On arrivalTest the parts
Pump, switches, seals and hoses are tested before anything is replaced.
First visitSource the part
If the part is not on hand, it is ordered and a return visit is arranged.
If a part is neededRepair and confirm
The part is replaced and the washer is checked through a cycle.
After the repairTell us the brand and the symptom.
- Across the Las Vegas valley
- Built-in and high-end brands
- Parts sourced for older models
Before the work begins
No. Stop using it and, if you can, turn off the water supply valves behind the machine until it has been checked. Repeated leaks can damage the floor underneath.