Las Vegas · Appliance repair
Ice Maker Repair
Built-in and freestanding ice makers back to full output, across the Las Vegas valley.
No icehas a short listof causes.
What to expect
- No ice or slow production
- Small or hollow cubes
- Water inlet valve replacement
- Frozen fill line repair
Common causes
- Frozen or blocked fill tubes
- Failed water inlet valves
- Clogged water filters
- Worn ice maker modules
Scheduling
CallOpen daily, 8 AM–10 PM. Tell us the appliance, the brand and what it is doing.
Serving 3 local communities(725) 777-7750What we fix onice makers.
The fault is diagnosed and explained before any repair goes ahead.
No ice or slow production
Check the water supply, filter and fill path before looking at the ice maker module.
Small or hollow cubes
Trace low water flow to supply pressure, a clogged filter or a failing inlet valve.
Water inlet valve replacement
Test the valve that lets water into the appliance and replace it if it sticks, leaks or will not open.
Frozen fill line repair
Clear a frozen fill tube and look for the reason it froze.
Ice maker module replacement
Replace the module once the water supply and fill path have been ruled out.
Leak diagnosis
Trace water near the ice bin or under the fridge to the fill tube, valve or supply line.
We follow the water from the supply lineto the ice tray.
Supply checked. Then the module.
An ice maker can only make what it is given, so the water supply and inlet valve are checked before the module itself.
Sub-Zero and other built-in ice makers are serviced along with refrigerator ice makers and stand-alone units.
Learn about our process
The failed part is confirmed before it is replaced.
What you notice
Little or no iceSymptomProduction has slowed or stopped, or the cubes come out small and hollow.
Likely cause
Too little waterDiagnosisA frozen fill tube, a clogged filter, low supply pressure or a failing inlet valve.
What gets checked
Filter, valve, fill tubeBefore repairThe water path is checked in order before the module is replaced.
From the first call to a working fill cycle.
Five stages, starting with the simplest checks. The module is replaced only once the water path has been ruled out.
Call us
Tell us the brand and whether the ice maker is in the fridge or stand-alone.
When you callCheck the supply
Water supply and the filter are checked first, since they are the simplest causes.
On arrivalTest the valve
The inlet valve and fill tube are tested for flow, blockage and ice.
First visitSource the part
If the part is not on hand, it is ordered and a return visit is arranged.
If a part is neededRepair and confirm
The failed part is replaced and the fill cycle is checked.
After the repairTell us the brand and the symptom.
- Across the Las Vegas valley
- Built-in and high-end brands
- Parts sourced for older models
Before the work begins
Small or hollow cubes usually mean the unit is not getting enough water, from low supply pressure, a clogged filter, or a failing inlet valve.