Las Vegas · Appliance repair
Microwave Repair & Installation
Over-the-range microwaves repaired or installed, across the Las Vegas valley.
No heat.Blown fuses.Dead keypads.
What to expect
- Not heating
- Won't start or shuts off
- Door switch replacement
- Turntable and motor repair
Common causes
- Failed magnetrons or diodes
- Worn door switches
- Blown internal fuses
- Control board faults
Scheduling
CallOpen daily, 8 AM–10 PM. Tell us the appliance, the brand and what it is doing.
Serving 3 local communities(725) 777-7750What we fix onmicrowaves.
The fault is diagnosed and explained before any repair goes ahead.
Not heating
Test the high-voltage parts, from the magnetron to the diode and capacitor, to find why food stays cold.
Won't start or shuts off
Check the door switches, internal fuses and controls that stop the microwave from starting or keep it shutting off.
Door switch replacement
Replace worn door interlock switches, a common reason a microwave blows its fuse or will not start.
Turntable and motor repair
Repair or replace the turntable motor, coupler and roller when the plate stops turning or grinds.
Control and keypad faults
Diagnose keypads and control boards that stop responding to presses.
Over-the-range installation
Mount and connect a new over-the-range microwave, test it, and clean up the work area.
We test the high-voltage parts, the switches and controls,and replace what failed.
Tested safely. Repaired or installed.
Microwaves are diagnosed and the failed part replaced, whether it is a door switch, a fuse, a high-voltage component or the control, and new over-the-range units are installed.
A blown fuse is often the result of a worn door switch, so the switches are checked before the fuse is replaced.
Learn about our process
The failed part is confirmed before it is replaced.
What you notice
Runs but won't heatSymptomThe light and turntable work, but food comes out cold.
Likely cause
Magnetron, diode, capacitorDiagnosisOne failed high-voltage part stops heating while everything else runs.
What gets checked
High-voltage circuitBefore repairEach part is tested with the charge safely discharged first.
From the first call to a working microwave.
Five stages. High-voltage parts are tested safely before anything is replaced.
Call us
Tell us the brand, model, and whether you need a repair or a new installation.
When you callCheck the symptoms
The microwave is run to see whether it heats, starts and responds.
On arrivalTest the parts
Door switches, fuses, high-voltage parts and controls are tested safely.
First visitSource the part
If the part is not on hand, it is ordered and a return visit is arranged.
If a part is neededRepair and confirm
The part is replaced, or the new unit mounted, and the microwave is tested.
After the repairTell us the brand and the symptom.
- Across the Las Vegas valley
- Built-in and high-end brands
- Parts sourced for older models
Before the work begins
Yes. New over-the-range microwaves are installed, mounted and tested, and the work area is cleaned up afterwards.