Las Vegas · Appliance repair
Dishwasher Repair
Leaks, poor cleaning and drain problems, across the Las Vegas valley.
Dirty dishes,leaks or waterleft behind.
What to expect
- Leaks under the door or cabinet
- Not draining
- Poor cleaning results
- Water inlet valve replacement
Common causes
- Clogged filters and drain hoses
- Failed inlet valves
- Worn door gaskets
- Wash pump failures
Scheduling
CallOpen daily, 8 AM–10 PM. Tell us the appliance, the brand and what it is doing.
Serving 3 local communities(725) 777-7750What we fix ondishwashers.
The fault is diagnosed and explained before any repair goes ahead.
Leaks under the door or cabinet
Trace water to the door gasket, the inlet valve, a hose connection or the pump.
Not draining
Check the filter, sump and drain hose, then test the drain pump.
Poor cleaning results
Check the filter, spray arms and wash pump, and look for hard-water scale.
Water inlet valve replacement
Test the valve that lets water into the appliance and replace it if it sticks, leaks or will not open.
Wash and drain pump repair
Test the wash and drain pumps and replace the one that has failed.
Control and sensor faults
Test the control board and sensors when the dishwasher stops partway or will not start.
We check the filter, the pumps and the valvebefore replacing anything.
Simple causes ruled out first.
Built-in dishwashers, including Kenmore, are diagnosed from the simplest cause up: filter and drain path first, then valves, pumps and controls.
Hard-water scale can build up on spray arms and in the sump, so it is checked for during the repair.
Learn about our process
The failed part is confirmed before it is replaced.
What you notice
Water left in the tubSymptomThe cycle ends with standing water, or the dishwasher stops partway through.
Likely cause
Filter, hose or pumpDiagnosisA clogged filter, a kinked or blocked drain hose, or a failed drain pump.
What gets checked
Drain path, then pumpBefore repairThe filter and hose are checked before the drain pump is tested.
From the first call to a clean cycle.
Five stages. The simple causes are ruled out first, so a pump is not replaced when a filter was the problem.
Call us
Tell us the brand and whether it leaks, will not drain, or cleans poorly.
When you callCheck the drain path
The filter, sump and drain hose are checked for blockages.
On arrivalTest the parts
Inlet valve, pumps, door seal and controls are tested.
First visitSource the part
If the part is not on hand, it is ordered and a return visit is arranged.
If a part is neededRepair and confirm
The part is replaced and a cycle is run to check filling, draining and the door seal.
After the repairTell us the brand and the symptom.
- Across the Las Vegas valley
- Built-in and high-end brands
- Parts sourced for older models
Before the work begins
Stop running it and dry the area. If water reached under the cabinet, leave the toe kick open so it can air out, and book a repair before the next load.